- Transportation Efficiencies
- EV Charging
- EV Charging
- Clean Transportation
- Clean Transportation
Beyond Ultra-Fast Charging: Part 2
The potential of automated drive has produced many a report theorizing about the likely impacts of automated drive technologies on the transportation system, the built environment, and more generally, society. Navigant Research is no stranger here; however, our tack is far more conservative than some others. The basic theory most of these reports (including ours) supports is that automation adopted primarily in passenger mobility schemes will drastically reduce transportation costs and increase passenger convenience. This leads to more transportation overall with higher dependency on automated light duty vehicles, but also less use (proportionally) of alternative transportation modes (bike, bus, rail, air, etc.).
The above means that automated vehicles are likely to be highly utilized and therefore automated mobility fleet managers are likely to desire durable vehicles with limited downtime for maintenance or refueling. To be competitive for automated services, battery EVs (BEVs) would have to rely on ultra-fast charging, which would make batteries less durable. Otherwise, they would require more advanced battery systems or significant increases in battery size (to bring charge rate [kW] and battery capacity [kWh] closer to a 1:1 ratio), either of which makes them more expensive.
More Pollution Regulations Are in the Future
At the same time, cities (where automated mobility services are likely to emerge) will probably adopt regulations limiting polluting vehicles within certain geographic boundaries. If they don’t, the ultimate impact of automation is likely more fossil fuel consumption. In such an environment, plug-in hybrids (like those employed by Waymo) may have the upper hand. Alternatively, this could be an opportunity for battery swapping.
Battery swapping notably has a poor record, but many of the barriers to battery swapping as a solution for the passenger BEV market don’t apply with automated mobility fleets. Battery swapping in part failed as a global strategy because it depended on OEMs agreeing on a common battery pack. In a managed fleet with vehicles from a single OEM, this is no longer a problem.
Is Battery Swapping the Answer?
Battery swapping solves reliability concerns, as the charge rate can be managed to optimize life and the battery can be enrolled in revenue generating grid services when off the vehicle. This would also make transportation electrification’s impact on the grid gentler. Additionally, swapping is a faster solution than the fastest wired or wireless charging solution and (as Tesla showcased) faster than liquid or gaseous refueling.
The last advantage is that in fully automated services, range is not as big of an issue as it is when there is a human driver. Theoretically, battery swap packs could be built smaller and added to the vehicle in increments to satisfy certain uses. As an example, instead of having two or more 200-mile battery packs per vehicle, managers could instead employ three or more 100-mile battery packs, which would further reduce overall system costs and risk.
It will be some time before such a solution might be employed. It is a later consideration in the evolution of mobility automation business models. The priority considerations are the development of the automated drive technology itself and the regulations to permit driverless vehicles. It is likely that initial services will leverage conventional refueling and/or recharging infrastructure until reliable business models have been produced. After that development, then competition within mobility services will drive such innovations.